Ascorepell SX

INTRODUCTION

ASCOREPELL SX is a water repellent treatment sealer specifically designed for concrete, brick, block and masonry. ASCOREPELL SX works better and lasts to help control eforescence and give a long-term waterbeading effect to water penetration. When cured it, the appearance of surfaces do not change and the non-film forming property will allow the substrate to breathe. It can be used on old or new structures. It can be applied on
exterior and interior on a long term basis.

 

RECOMMENDED APPLICATIONS

Exposed brick, Block and RCC work
Stucco walls
Concrete roof tiles and unglazed floor tiles
Waterproofing and protection of Concrete constructions
Waterproofing and Protection of Drywall and Cement-boards
 

FEATURES & BENEFITS

Easy to apply.
Fast drying and low odor.
Excellent penetration.
Breathable - excellent vapor transmission.
Penetrates fully into the surface but will not alter appearance.
 

TECHNICAL PROPERTIES

Chemical Base Siloxane
Solids 100 % Concentrate
Appearance Clear Yellow
Specific Gravity 0.79 - 0.81Kg/l
Surface Curing 8 - 12 hours
Full Cure 7 days

COVERAGE

ASCOREPELL SX should be applied in two coats. 4 - 4.5 m²/l per coat and applied in two layers. This coverage is based on application by spray/ roller/ brush onto a smooth surface in optimum conditions. Factors like surface porosity, temperature and application method can alter consumption.

PACKAGING

Available in 1.5 L jerrycan and 20 L pail

STORAGE

12 months from production date, if stored in original, unopened packaging in places protected from moisture, sun exposure and frost.

 

APPLICATION PROCEDURE

SURFACE PREPARATION

All surfaces must be clean, dry and free from any contaminates such as dust, oil, wax, grease, curing agents or other substances that may affect adhesion performance. Building debris such as off cuts, sawdust, nails, screws, plaster, wood etc., must be thoroughly cleaned with the help of wire brush - vacuum cleaner - damp sponge.

MIXING

Do not dilute with water or any other solvents.

APPLICATION METHOD

  1. i. ASCOREPELL SX is pre-mixed and ready to use.
  2. ii. ASCOREPELL SX may be applied by brush or paint roller.
  3. iii. Prior to applying to general surface area, pre-treat all cracks, joints, corners and coves first.
  1. iv. Always apply a test patch in an inconspicuous area and confirm the results are acceptable for continuing.
  2. v. ASCOREPELL SX is best applied with a low pressure sprayer.
  3. vi. Airless spray equipment is more efficient for larger projects. Can also be applied by brush or roller.
  4. vii. Apply two coats at the recommended rates of coverage.
  5. viii. Do not allow product to pool on the substrate surface.

CURING

Optimum performance level is reached after 24 hours of curing.

* Kindly follow the required health and safety precautionary measures. (Refer our Safety Data Sheet for more details)

 
 

BROCHURE